Injection Molding Custom Rubber Parts

1.Injection Molding Custom Rubber Parts- Molding Processes

Injection molding is one of the important manufacturing methods in rubber molding processes. The rubber is pre-heated before being injected into the mold. After pre-heated, the rubber flows more readily into the mold, allowing for higher cure temperatures, shortening the curing cycle. Rubber injection molding presses provide tight clamping, which results in little or no flash. We have injection machines with tonnage of 100 to 300 tons which can improve the compactness and functionality of products (especially the functionality of shock-absorbing products).

Advantages of Rubber Injection Molding

Fast production.

Low labor costs.

Can be used to produce very small parts.

Leaves little post-production scrap.

Good product consistency.

Reduced requirements for finishing.

Good dimensional control.

Disadvantages of Rubber Injection Molding

Small runs of parts can be costly.

Requires large production runs to really be efficient.

Not all compounds, or durometers, are suitable for this process.

High initial tooling and machinery cost.

Part design restrictions.

2.Application of Injection Molding Rubber Parts.

Rubber injection molding is an ideally suited for mid-to-high-volume production and where tight tolerances, part consistency or over-molding are required. It is widely used for the following products:

●Rubber boots

●Rubber gaskets

●Rubber seals

●Rubber grommets

●Colored rubber products

●Rubber bumpers

●Rubber grips

●Rubber diaphragms

●Rubber bellows

●Rubber shock absorbers

●Rubber to metal bonding products

●Complex rubber products

●Vibration control parts / vibration isolation parts

●Chemical or corrosion resistant parts

●Abrasion-resistant parts

●Custom rubber parts

3.Certifications for Injection Molding Custom Rubber Parts

We serve our customers with high quality Injection Molding Custom Rubber Parts by strictly follow ISO 9001:2015 and IATF 16949.

4.Quality Control

5.Payment,Deliver,Shipping And Serving

6.FAQ

1.Are you a trading company or a manufacturer?

LJ RUBBER is 100% Manufacturer of Molded Rubber Products

2.Where is your factory located?

Xiamen City, Southeast of China

3. How many factories do you have?

We have two factories:

1. Head office: SLD RUBBER was found in 1985, specialize in producing MIXING RUBBER Componds(Synthetic Rubbers)

2. Molded Manufacturer: LJ RUBBER was found in 2005, specialize in manufacturing Custom Rubber Molded Products."

4. What is your MOQ?

Because all rubber products are custom made, the MOQ will depend on how much the batch of rubber will yield for the rubber part that you requesting.

6. What kind of test can you do to ensure rubber property of my applicaton?

We do the testing of following:

Hardness

Tensile Strength

Compression Set

Aging Resistance

Ozone Resistance

Abrasion Resistance

Tear Resistance

Oil Resistance

High&Low Temperature Resistance

RoHs, Reach according to your requirements."